← All installation guides

How to install shoelace aglets

An aglet is the hard tip on the end of a shoelace. It stops the lace fraying and makes it easy to thread. These steps are for our screw-on metal aglets, which replace worn or plain tips.

Aglet pack: four gold aglets, four screws and a mini Phillips screwdriver

In the pack

  • 4 aglets (2 pairs)
  • 4 aglet screws
  • 1 mini Phillips head screwdriver

You'll also need: a pair of laces. Optional: scissors and super glue.

Fitting your aglets

  1. Check the parts. Make sure each screw turns into its aglet before you start.
    Testing a screw in a gold aglet with the mini screwdriver
  2. Lace your shoes first. That way you know the laces are where you want them before the tips go on.
  3. Push a lace tip into the aglet. Slide it into the hole at the bottom of the aglet. If the old tip is too long to fit, trim about a quarter of it off.
    White lace tip pushed into the open end of a gold aglet
  4. Screw it in place. Turn the screw into the hole on the side of the aglet with the screwdriver until the lace is held firmly.
    Screwdriver fixing the aglet screw into the side of the aglet
  5. Repeat for the other three tips.
    Two white laces finished with gold aglets

Tip

  • For a stronger hold, put a small drop of super glue on the lace tip before you push it into the aglet.

Loading...
Loading...