← All installation guides

How to install elastic no-tie shoelaces (smart lock)

These steps are for our smart lock elastic laces. You lace them once, set the tension with your shoe on, then lock the ends instead of tying a bow. Do one shoe from start to finish, then copy it on the other.

Smart lock elastic laces pack: two red elastic laces, two locks and two end caps

In the pack

  • 2 elastic laces (1 pair)
  • 2 smart locks
  • 2 end caps

You'll also need: a pair of scissors.

Fitting your smart lock laces

  1. Take out your old laces.
  2. Lace the elastic through the eyelets. Use your usual lacing pattern and leave both ends long for now.
    Blue elastic lace being threaded through the eyelets of a white sneaker
  3. Put the shoe on and walk around. If the fit is too tight or too loose, adjust the lace along the eyelets until it's comfortable.
  4. Fit the lock. Press the button on the smart lock and thread both lace ends through it.
  5. Tighten. Hold the button down and slide the lock up towards your foot. Let go and it holds the lace where it is.
    Hands sliding the smart lock up the elastic laces on both shoes
  6. Check the fit again. Stand up and walk around. Press the button to loosen or slide the lock to tighten until it feels right.
  7. Trim the ends. Cut each end 5 to 8 cm (2.0" to 3.1") below the lock. The spare length lets you adjust the fit later.
  8. Fit the end caps. Push each trimmed end into an end cap and snap it shut.
    Trimming the lace end with scissors, then pushing it into the red end cap
Both shoes finished with red smart lock elastic laces

Tips

  • Trim a little at a time. You can always cut more, but you can't add length back.
  • Elastic slowly loses some stretch with wear. If your shoes start to feel loose, slide the lock up to take up the slack.
  • Have a different lock? Capsule, magnetic, tip, press and anchor locks follow the same steps up to the lock itself. Check the product page for your lock.

Loading...
Loading...